G31
G31 wird in RepRapFirmware (RRF) verwendet, um Eigenschaften des Z‑Probes festzulegen.
created on
Friday, 02 January 2026
by
Stefan Trucker
Tag: G-Code
G29
G29 ist der zentrale Befehl für automatisches Bed‑Leveling (ABL) oder Mesh‑Leveling. Er wird verwendet, um: das Bett zu vermessen ein Höhen‑Mesh zu erzeugen das Mesh zu aktivieren oder zu deaktivieren gespeicherte Meshes zu laden oder zu speichern Z‑Korrekturen während des Drucks anzuwenden Der ...
created on
Friday, 02 January 2026
by
Stefan Trucker
G28
G28 führt eine Referenzfahrt (Homing) durch. Dabei fährt der Drucker jede Achse zu ihrem Endschalter oder Sensor, um die Nullposition zu bestimmen.
created on
Friday, 02 January 2026
by
Stefan Trucker
G12
G12 führt eine automatische Düsenreinigung aus.
created on
Sunday, 28 December 2025
by
Stefan Trucker
G11
G11 is the counterpart to G10. This is the unretract, i.e. material is pushed back into the nozzle but not extruded, so the material does not leave the nozzle.
created on
Sunday, 28 December 2025
by
Stefan Trucker
G5
G5 performs a quadratic Bézier curve movement. This means the printer follows a smooth, mathematically defined curve determined by: the start point (current position) a control point the end point This allows extremely smooth curves without many small G1 segments. Parameters: Parameter Meaning X ...
created on
Saturday, 20 December 2025
by
Stefan Trucker
G2
G2 performs a clockwise circular or arc movement. It is used to print arcs or circles more smoothly than approximating them with many G1 segments.
created on
Saturday, 20 December 2025
by
Stefan Trucker
M106
Lüftersteuerung Was macht M106? M106 steuert den Bauteilkühl‑Lüfter (Part Cooling Fan). Das ist der Lüfter, der das frisch extrudierte Filament kühlt – nicht der Hotend‑Kühlkörperlüfter. Mit M106 kannst du: den Lüfter einschalten die Drehzahl einstellen mehrere Lüfter separat steuern (bei ...
created on
Friday, 21 November 2025
by
Stefan Trucker
G1
G1 is one of the most essential G‑code commands in FDM 3D printing. It performs a linear movement, either: with extrusion (if an E value is included) or without extrusion (if no E value is present) G1 controls almost all printed paths: perimeters, infill, supports, top layers, etc. Codesample G1 ...
created on
Friday, 21 November 2025
by
Stefan Trucker
Page 2 of 3