Firmware Setups

Thermistoren

NTC100K B3950

[thermistor Trianglelab-NTC100K-B3950]
temperature1: 25
resistance1: 103180
temperature2: 150
resistance2: 1366.2
temperature3: 250
resistance3: 168.6

Semitec 104NT-4-R025H42G

[thermistor ATC Semitec 104NT-4-R025H42G]
temperature1: 25
resistance1: 100000
temperature2: 160
resistance2: 1074
temperature3: 300
resistance3: 82.78

CMFB103F3950FANT

[thermistor CMFB103F3950FANT]
temperature1: 0.0
resistance1: 32116.0
temperature2: 40.0
resistance2: 5309.0
temperature3: 80.0
resistance3: 1228.0

Will man den Lüfter des Raspberry Pi über einen deiner GPIO Pinns steuern, so muss man auf dem Ausgang PWM aktivieren und richtig konfigurieren.

Einstellen während der Installation

https://github.com/QuietWorry/Pi5-Mainsail

Click "Next" on RPI Imager
Click "Edit Settings"
Enable "Set hostname" and change hostname as desired
Set Username and password
If using WiFi: Enable and set SSID and Password for your network, then select correct country
Enable and set locale settings
Navigate to "Services" tab and enable SSH with password authentication (or pub-key authentication)
Click "Save" at the bottom
Click "yes" to apply OS customization settings
Click "yes" to erase all data on SD if prompted
Wait for OS to write and verify
Safely remove SD and install on Pi 5

Shell:

login in to your Pi via SSh

read hostname

$ hostname
raspberry

change hostname
$ sudo hostnamectl set-hostname

sudoedit /etc/hosts

to change 

https://linuxconfig.org/how-to-set-hostname-on-raspberry-pi

In diesem Artikel sind alle Schritte beschrieben, wie man das SKR Mini V3 E3 von Bir Tree Tech mit Klipper konfiguriert.

sensor_type:
#   One of "MAX6675", "MAX31855", "MAX31856", or "MAX31865".
sensor_pin:
#   The chip select line for the sensor chip. This parameter must be
#   provided.
#spi_speed: 4000000
#   The SPI speed (in hz) to use when communicating with the chip.
#   The default is 4000000.
#spi_bus:
#spi_software_sclk_pin:
#spi_software_mosi_pin:
#spi_software_miso_pin:
#   See the "common SPI settings" section for a description of the
#   above parameters.
#tc_type: K
#tc_use_50Hz_filter: False
#tc_averaging_count: 1
#   The above parameters control the sensor parameters of MAX31856
#   chips. The defaults for each parameter are next to the parameter
#   name in the above list.
rtd_nominal_r: 100
rtd_reference_r: 430
rtd_num_of_wires: 2
#rtd_use_50Hz_filter: False
#   The above parameters control the sensor parameters of MAX31865
#   chips. The defaults for each parameter are next to the parameter
#   name in the above list.

Der Ramps 1.4 hat den SPI Port rechts unten

dazu wurde PIN D40 (PL0) als CS genommen